Register

Thank you ! Your request has been transmitted!
Error! Please try again!
Please fill out all required fields (*)!
Mr
Mrs
The data collected in this form is used by CATU to enable you to consult our product catalog and to create your list of favourite products. You have the right to access your data. Find out more about how we manage your data and your rights.
I agree to subscribe to the CATU newsletter to receive information on new products and solutions. Please note that you can unsubscribe at any time using the unsubscribe link in the newsletter. Find out more about data management and your rights.
* Required fields

Already registered?

Not registered?

You will receive an e-mail with instructions on how to reset your password in a few moments
If you do not receive this e-mail, please check your junk mail

Our product selection




  2. Products
  3. Installation controllers and measuring devices
  4. M-951735

M 951735


 M-951735 

Standards
EN 61010-031
IEC 664
LV circuit breaker identification device

Application: 

  • Device especially designed to identify on the switchboard and under voltage the protection device corresponding to the voltage source (socket, ceilinglight, electrical machine terminal block,...) whose origin is wished to know.
  • Automatically recognises the type of supply: 230 V between phase and neutral or 400 V between phases.
  • Possible detection of the signal with a maximum current of 80 A.

Features: 

  • Current limitation by HRC fuse (extractor).
  • Low-battery indicated by change of diode colour (green to orange).
  • Receiver with integrated self-test and sensitivity calibration by thumbwheel.
  • CAT II 600 V

Composition: 

  • 1 x MX-300/SC power supply unit.
  • 1 x receiver MX-300/R.
  • 1 x connecting cable L 1.5 m with 230 V plug M-951735
  • 1 x set of black and red cords L 2.5 m M-951736
  • 1 x set of 2 alligator clips Black and Red DX-02006
  • 1 x 9 V battery type 6LR61.

Data Sheet



Reference Dimensions (mm) Weight (kg)
M-951735 160(L)*60(H)*60 0.125